I had an idea in 2013 for a ceiling fan that could be used as a decorative piece in any room.
The idea was to make an original design based on the artwork on the ceiling tiles, and then build it into a cool piece of wall art.
The original ceiling fan was a bit large, and was not very light.
The new version, however, is a much lighter design, which was easier to assemble and much more practical for me to build.
I started by taking the original design and adding some new tiles.
The old design had four large round tiles with the words “Ceiling Fan Direction” written on them.
I also added a few new tiles in a vertical line to help me add dimension.
I decided to use an ordinary wooden dowel for the dowels.
The diameter of the dowel is about two and a half inches, and it is about the same length as the dowell.
I used a little piece of paper that I could wrap around the dowells dowel and glue it to the back of the back panel.
I put two thin strips of tape on the back to hold it in place.
I then took a small square of cardboard, cut it in half, and cut out the sides with scissors.
The dowel was put on the cardboard, and the sides were glued to the cardboard.
Then, I carefully rolled the cardboard into a ball, folded it up, and taped it to a piece of aluminum foil.
Then I used the aluminum foil to cover the top of the aluminum piece.
I cut the cardboard in half again and then used the scissors to cut out another piece of cardboard.
The aluminum piece was then placed over the aluminum dowel, and I added the aluminum.
Then using a glue gun, I screwed the aluminum pieces onto the aluminum backing piece.
The whole assembly was done in about two hours.
I wanted to make this fan light and have it be a good piece of decorative art, so I decided that I wanted a fan that would take advantage of the radiant heat of the ceiling.
I decided to make the fan with two fans, and used the one that had the “direction” printed on the side.
The other fan had the directions on the front, so that the fan could be easily flipped around.
The first fan was on the left, and had two LEDs on it.
I made the other fan on the right, which has two LEDs, but is a slightly different shape.
The directions were written on the inside of the fan.
When the fan was turned, the light on the LED would change to red, and when the fan turned back, the LED on the fan would change back to blue.
The red LED light would be on when the door is open, and blue when it is closed.
I glued the LED lights on to the aluminum back of my fan.
The fan is now the perfect piece of decoration to hang around the walls of your room.